|
|
|
Who's Online
There currently are 5796 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
;
I got the manual quickly after the payment was transfered (1 day). The manual was exactly what i needed and the updates via e-mail were great. Thanx!
;
I've looked for this manual all over that internet, you guys had it and to a good price. A++++
;
I've looked some time for this manual, you guys had it and to a good price. A++++
 ;
factory technician level - complete with board views :
( removing chassis from cabinet , only thing missing ) ;
on weekends , staff is not available so - be patient .
DOLBY® DIGITAL OR DTS® (OR OTHER DIGITAL SURROUND MODE) CONNECTION
RECEIVER LINE LEVEL IN SUBWOOFER L LFE R
LFE OUT
Use this installation method for Dolby Digital, DTS or other digital surround processors: Use the line-level input jack marked �LFE� for the Low-
Frequency Effects channel. Connect this jack to the LFE output or subwoofer output on your receiver or amplifier. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier. Make sure that you have configured your surround sound processor for �Subwoofer On.� Also configure
your receiver for 5.1-, 6.1or 7.1-channel operation as appropriate. The front left, front right, center and rear speakers should all be set to �Small.� If your receiver allows you to set the crossover frequency between the subwoofer and the main speakers, select 100Hz or the setting that is the closest frequency below it.
DOLBY PRO LOGIC® (NON-DIGITAL) � LINE LEVEL
Use this installation method for Dolby Pro Logic applications (not Dolby Digital, DTS or other digital processing), where the receiver/processor is equipped with a subwoofer output, or a volumecontrolled preamp (line-) level output:
Left Front � + Center �
Use RCA-type interconnects to connect the line-level subwoofer outputs on your receiver or amplifier to the line-level inputs on the subwoofer. IMPORTANT: Do not use the LFE input on the subwoofer with Dolby Pro Logic processors.
Right Front � +
+
Subwoofer Line Level In
L R
NOTE: If your receiver or amplifier has only one subwoofer output jack, then you will need to use a Y-connector (not included). Plug the male end of the Y-connector into your receiver or amplifier�s subwoofer output jack, and connect each of the two female ends to separate RCA-type interconnects. Finally, plug the RCA-type interconnects into the linelevel inputs on the subwoofer. Connect each speaker to the corresponding speaker terminals on your receiver or amplifier.
Left Front
Receiver Subwoofer Out
Right Front
�
Left Surround
+ � +
R
�
L
+
� � +
+
Right Surround
Make sure your receiver or processor is correctly configured to indicate that the subwoofer is �On.�
� +
�
+
Center Surround Back Surround Back Left Right
Left Surround � +
Surround Back Left � +
Surround Back Right � +
Right Surround � +
5
5
 $4.99 CSS10 JBL
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
