Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Text excerpt from page 3 (click to view)
two. Hookup
Connection Tips
Wire Length Up to 20 ft. Up to 30 ft. Greater than 30 ft. Recommended Speaker Cable Size 16 gauge 14 gauge 12 gauge or heavier
Preparing the Speaker Cable
1. Determine the length of wire necessary to connect your amplifier to the speaker that is farthest away. Remember to allow for extra cable to be able to conceal it under baseboards, or run it around corners. 2. Keep both cable lengths the same in order to help maintain proper signal balance and imaging. 3. Separate about one inch of the two conductors that make up each cable. Then strip off about 3/8" of insulation. 4. Twist each conductor�s thin wires into a tightly bunched spiral. 5. Identify a difference between the two conductors. This may be done in various ways, depending upon the type and brand of cable you are using.
Some of the More Common Differentiating Marks for Conductors Are:
� Different color wire � A strand of thread in one � A colored line on one con-
ductor�s outer insulation
� Raised ribs on one conduc-
conductor
tor�s outer insulation � A printed (+) marking on one of the insulators
The terminals on the SVA Series loudspeakers can accept several types of speaker cable connections. Remember to connect the red (+) terminal on the receiver/amplifier to the red (+) terminal on the speaker and the black (�) terminal on the receiver/amplifier to the black (�) terminal on the speaker.
